If the coded override feature was enabled by the installing dealer, you will need to follow these procedure:ġ. The security system will re-arm the next time the ignition key is turn off and the vehicle's doors are closed. Note: If the automatic arming feature is enabled on your system. Press and release the emergency override button (The security system will turn off). Turn the ignition key to the ON position.Ĥ. Locate but do not press the valet/override switch yet (it should be a small black button installed under the dash within reach of the driver)ģ. Enter the vehicle (the security system will trigger.)Ģ. Provided that your system is not programmed for coded override, the standard emergency override is as follows:ġ. This is why having a certified alarm installer do this work is a good idea, as they can put your account with the monitoring station on 'test' so alarm signals are recorded for testing purposes but are not acted upon. Be careful of setting off the alarm, as your monitoring station may dispatch police, etc. After about 15 seconds, the panel will have auto-enrolled each attached device. by entering into programming mode and exiting. After that, it would be a good idea to re-enroll all of your attached sensors, etc. I would first try to re-start the control panel by removing the power and battery connection for a few seconds and plugging it back in. However, this shouldn't keep the alarm panel from arming up. If the power was out for 5 hours and the control panel still shows 'low battery', it's probably time to replace the battery for the control panel.
0 kommentar(er)
